11
Note: Your machine may not match the image. For reference only.
1. Using a #2 Phillips screwdriver, loosen and remove the hardware that
attaches the Fender to the Main Frame. Set the Fender and hardware
safely aside for reassembly.
NOTICE: Hold the Brake Cover so that it does not fall.
2. Loosen the Resistance Knob (A) to the minimum resistance setting.
3. Loosen and remove the hardware that attaches the Brake Pad (B) to
the Brake Assembly bracket (C).
4. Slide the Brake Pad (B) out of the Brake Assembly bracket (C).
Disconnect the data cable from the console before you service this machine.
X2
X2
A
B
C
To Next Page
Loading...
