Schwinn IC7 - Unit Measurement and Compliance

7
&KDQJLQJ8QLW0HDVXUHV(QJOLVK,PSHULDO0HWULF
The default distance unit is kilometers (K). You can switch units between kilometers and miles before you start a workout,
or after you reset the Console. To change the units, push UP and DOWN together and hold 3 seconds. When the display
begins to blink, use the arrow button to change the units (K or M). Press any key to save.
Condition/Problem 7KLQJVWR&KHFN Solution
Unit rocks/does not sit
level
Check level adjustment Levelers may be turned to level machine.
Check surface under unit Adjustment may not be able to compensate for extremely un-
even surfaces. Move machine to level area.
3HGDOVORRVHXQLWGLႈFXOW
to pedal
Check pedal to crank
connection
Pedal should be tightened securely to crank arm. Be sure con-
nection is not cross-threaded.
Check crank arm to axle
connection
Crank arm should be tightened securely to axle.
Check drive belt tension Refer to the “Adjust the Belt Tension” procedure in the Service
Manual.
Clicking sound when
pedaling
Check pedal to crank
connection
Remove pedals. Make sure there is no debris on threads, and
reinstall the pedals.
Seat post movement Check locking pin Be sure adjustment pin is locked into one of the seat post
adjustment holes.
Check locking knob Be sure knob is securely tightened.
Resistance is uneven
when pedaling
Brake assembly Refer to the “Lubricate the Brake” procedure in the Service
Manual.
FCC Compliance
!
&KDQJHVRUPRGL¿FDWLRQVWRWKLVXQLWQRWH[SUHVVO\DSSURYHGE\WKHSDUW\UHVSRQVLEOHIRUFRPSOLDQFHFRXOGYRLGWKH
user’s authority to operate the equipment.
This product complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
1RWH This product has been tested and found to comply with the limits for a Class B digital device, pursuant to CFR47
Part 15 Subpart B of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. In the unlikely event that this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the
HTXLSPHQWRႇDQGRQWKHXVHULVHQFRXUDJHGWRWU\WRFRUUHFWWKHLQWHUIHUHQFHE\RQHRUPRUHRIWKHIROORZLQJPHDVXUHV
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
This product complies with the European Radio Equipment Directive 2014/53/EU.