5
Connect to an Electrical Outlet:
The balance is supplied with a 100/240, 50/60 Hz automatic switching, remote power supply. This power
supply will work with most electrical outlets. However, before making any connections, verify that the
power (VAC) requirement shown on the remote power supply is compatible with the AC power outlet to
which the balance will be connected.
Note: First plug the round 2.5mm connector into the balance’s rear panel receptacle. Then, plug
the power supply into a grounded AC outlet.
Note: Scientech recommends that the balance be plugged into an electrical outlet at all times.
This insures the balance is always warmed up and ready for use.
Turn the balance on:
Press the ON/OFF button one time to turn the balance on and observe the following turn on sequence.
Allow the balance to
warm up for at least 1
hour.
Good Measurement Pracces:
(As quoted from the Mass Standards Handbook by Troemner, 3-015BKT rev 1/03)
There are numerous steps that one can take in order to improve the quality of a mass measurement
system. However, they usually fall within three main categories: the equipment, the environment, and
the operator. If even one of these areas is neglected, it can have a dramatic negative impact on your
results. Although these suggestions are not meant to be all encompassing or all-inclusive, the im-
provements that can be made following these simple guidelines are extraordinary.
To Next Page
Loading...
