②
Open the holder ring/rubber spacer of the keypad and fix it on the
handlebar, adjust it to a proper facing angle. Use a M3 Hex Wrench to fix
and tighten the screws. Standard fixing torque: 1N·m.
*Damage due to excessive fixing torque is not covered by warranty.
③ Plug the 5-pin connector of the display to the coupling connector of the
Controller.
7. Serial Code
Example： 111 22 333333 555 6666
111：Customer Code
22：Protocol Code
333333：P.O. Date （YYMMDD)
555：Order Receiving Number
6666: Production Date （YYMM)
Ⅲ. Operation
1. Display Interface
1.1 Riding Interface
Status: Real-time Riding Status: Bluetooth, Front Light, Brake, Low
Voltage, Turning, Cruise, Drive Status, etc.
Marked at the
back of display
To Next Page
