SCIWIL SW-M808X - Serial Code; Ⅲ. Operation; Display Interface; Riding Interface

-
6
-
② Open the holder ring/rubber spacer of the keypad and fix it on the
handlebar, adjust it to a proper facing angle. Use a M3 Hex Wrench to fix
and tighten the screws. Standard fixing torque: 1N·m.
*Damage due to excessive fixing torque is not covered by warranty.
③
Plug the 5-pin connector of the display to the coupling connector of the
Controller.
7. Serial Code
Example：
192 2 1 210603011
192：Customer Code
2：Protocol Code
1：Program can be overridden（0 means cannot be reprogrammed）
210603011：P.O. (purchase order number)
Ⅲ. Operation
1. Display Interface
1.1 Riding Interface
 Status: Real-time Riding Status: Bluetooth, Front Light, Brake, Low
Voltage, Turning, Cruise, Drive Status, etc.

Battery Status: Residual Battery Percentage

Multi-Function Section: ODO (total range), TRIP (single ride range),
MAX (max. speed), AVG (average speed), TIME (riding time), VOL
(battery voltage), Wh (motor power), CUR (current), etc.
 Assist Level Mode: 3/5/9 Levels available.
36V
Marked at the
back of display