(0km/h), the display will be auto-off. Auto-off time can be set in the
Settings.
3.2 Assist Level
Press the Plus Key or Minus/Walk Assist Key to switch assist levels. There are
5 levels by default: 0/1/2/3/4/5. 0 means no assist power.
3.3 Toggle Displays
When the display is on, press the Info Key to toggle among ODO (total
range), Trip (single trip range), TIME (riding time) etc.
3.4 Light On/Off
Turn on the Front Light: when the front light is off, press the Light Key to
turn it on, and the light icon will be shown on the riding interface (to remove
this functions, please reconfigure the controller).
Turn off the Front Light: when the front light is on, press the Light Key to
turn it off, and the light icon will be off on the riding interface.
3.5 Walk Assist Mode
Engage Walk Assist Mode: On the riding interface, press and hold the
Minus/Walk Assist Key to enter walk assist mode. Hold the Minus/Walk Assist
Key to engage walk assist mode, the walk mode icon will be shown on the
riding interface, the real-time speed will be shown in the speed section.
Disengage Walk Assist Mode: release the Minus/Walk Assist Key to
disengage the walk assist mode, the icon will off on the riding interface.
3.6 Dual Drive Control (enabled by controller)
On the riding interface, press and hold the Plus Key to switch the drive mode,
which will be toggled in turn as Rear Drive -> Front Drive -> Dual Drive, and
the corresponding wheel of the icon on the down right corner will blink (e.g.
the rear wheel of the icon will blink in Rear Drive mode).
To Next Page
