② Open the holder ring/rubber spacer of the keypad and fix it on the
handlebar, adjust it to a proper facing angle. Use a M3 Hex Wrench to fix
and tighten the screws. Standard fixing torque: 1N·m.
*Damage due to excessive fixing torque is not covered by warranty.
③
Plug the 5-pin connector of the display to the coupling connector of the
Controller.
7. Serial Code
Example： 192 2 1 210603011
192：Customer Code
2：Protocol Code
1：Program can be overridden（0 means cannot be reprogrammed）
210603011：P.O. (purchase order number)
Ⅲ. Operation
Marked at the
back of display
To Next Page
