SECTION
E
IMPORTANT!
THE
DATA
CONNECTORS MUST BE PROPERLY ALIGNED BEFORE INSERTING THEM INTO
THE
DATA
SOCKETS. THERE IS A SMALL NOTCH/TAB FEATURE INSIDE EACH CONNECTOR
FOR ALIGNMENT.
DO
NOT
TWIST OR TURN
THE
CONNECTOR WHILE INSERTING. DOING
SO WILL RESULT IN IRREPARABLE DAMAGE
TO
THE
CONTACT PINS
OF
THE CABLE OR
DEVICE. ONCE THE CONNECTOR IS SEATED, HAND TIGHTEN ONLY.
TERMINATOR PLUG
This plug must
be
installed into Distribution Module's open 8-pin female connector,
or
if
multiple
Distribution Modules are used,
it
must
be
connected
to
the
last Distribution Module
in
the chain.
Note: The terminator will function
in
either one
of
the 8-pin connectors on
the
Distribution
Module. Align
the
arrow
on
the
connector
to
the notch in
the
Distribution Module.
©2022
SCOSCHE INDUSTRIES, INC.
Distribution Module
Battery Connection View
7
M8RIX 07/22
To Next Page
Loading...