12 scott-sports.com 13
GENIUS
BIKE OWNERS MANUAL
12 scott-sports.com 13
GENIUS
BIKE OWNERS MANUAL
ENGLISH
To change the rolls to match another fork brand pls follow the drawings below:
ASSEMBLY OF THE REMOTE CABLE
Important:
Please make sure the lockout of SRAM/RockShox or FOX fork is activated after
transport correctly. Therefore please compress fork 5-10 times before following the
manual on remote cable installation and adjustment.
The lever should show on the downside of the cable roll the brand name of the fork
you are going to use. Please do not try to use a RockShox roll with a FOX fork or vice
versa.
1. To assemble the cable please bring the lever into the Descent Mode, push the
cable into the lever-eyelet as shown on drawing below, push it through the pre-cut
cable housing and fix it at the assembly unit on top of the right side of the fork crown.
2. Fix the cable with the 2mm allen screw on the barrel adjuster on the fork crown
with a tightening torque of 0.9Nm/8 lb/in, cut the cable and secure it with a cable
end-cap. Please refer for this action also to the manual of SRAM/RockShox or FOX
attached to the bike.
TIP:
To check for accurate cable tension,
please try to move the plastic end cap of
the cable housing at the barrel adjuster
on the remote lever. There should be “no-
play” between cap and barrel adjuster.
In case of “play” please turn the barrel
adjuster clockwise until “no-play”.
To Next Page
Loading...
Need help?
General
