ENGLISHENGLISH
155 |
MOUNTAIN BIKE AND MOUNTAIN BIKE-PEDELEC | ORIGINAL OPERATING INSTRUCTIONS 2017ORIGINAL OPERATING INSTRUCTIONS 2017 | MOUNTAIN BIKE AND MOUNTAIN BIKE-PEDELEC
| 154
b ca
NOTE!
U
For more information on the safekeeping and storing of your SCOTT
pedelec see the chapter “Information for proper handling of the recharge-
able battery” and the system instructions of your drive manufacturer on this
SCOTT info CD.
WHAT TO BEAR IN MIND WHEN SERVICING SCOTT SPEED PEDELECS
Please note that in the case of SCOTT speed pedelecs only certain components
are allowed to be replaced, otherwise there is the risk of loosing the operating
licence and the insurance cover. Only use spare parts confirmed by experts’
reports on the approval for your SCOTT speed pedelec. As an alternative you
may also go through an individual approval process by a technical inspection
authority of your country. To be on the safe side, be sure to only use original
spare parts.
Components which must not be replaced or only after a type test, e.g. carried
out by a technical inspection authority: Frame, fork, drive unit (a), battery (b),
tyres, rims, brake system, front and rear light, kickstand, handlebars, stem, com-
mand console/display (c) and licence plate frame.
The following components can be replaced, even without any further test:
Pedals (pedal reflectors are compulsory), mudguards (with rounded edge at the
front mudguard), pannier rack, saddle and rubber grips on the handlebars, gear
components (provided the highest transmission remains identical), seat post,
chain, headset, inner tube and hub as well as bell and rear view mirror (when
replaced by equivalent models).
CAUTION!
S
In the case of SCOTT speed pedelecs be sure to only assemble original
spare parts, otherwise the operating licence expires.
To Next Page
Loading...
Need help?
General
