SCRAM GPS
Quick Reference Guide
i
©
2017 Alcohol Monitoring Systems, Inc. All rights reserved. Information in this
document is confi dential and proprietary to Alcohol Monitoring Systems, Inc.
Such information is subject to change without notice and does not represent
any commitment or promise on the part of Alcohol Monitoring Systems, Inc. Any
software described in this document is furnished under a license agreement.
No part of this manual may be reproduced or transmitted in any form or by any
means, electronic or mechanical, including photocopying and recording, for any
purposes without the express written permission of Alcohol Monitoring Systems,
Inc.
Please read, understand, and follow all information contained in this manual prior
to using the SCRAM GPS bracelet. Retain this manual for future reference.
Patents: www.scrampatents.com
Intended Use
The SCRAM GPS Bracelet is part of a location tracking and monitoring system and
transfers data to a computerized monitoring network. This equipment is intended
for use on individuals being monitored by a trained supervising authority.
Health and Safety Notice
WARNING
Improper installation or use of this
SCRAM device may cause injury.
Refer to Health and Safety Notice
at www.scramsafety.com or on
SCRAM
NET Help page and follow
instructions to avoid injury.
Cleaning
Properly clean and disinfect SCRAM GPS bracelets before installation using
instructions provided on the SCRAMNET Help page.
To avoid damaging equipment, use only cleaning and disinfecting products
approved by SCRAM Systems on the SCRAMnet Help page. Never use citrus or
pine-based cleaning products. To avoid contaminating alcohol sensors within
SCRAM Systems products, never use alcohol or alcohol-based cleaning products.
Battery Warnings
Caution - Contains Li-ion or Li-polymer battery. Do not heat, throw into fi re,
deform, short circuit, immerse in or wet with water.
Caution - Risk of Explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to the instructions.
To recharge use only the provided SCRAM GPS charger. Connect the external
charger by sliding terminal connector into the housing slot.
To Next Page
Loading...
