R1387 DCM2461/SCRIGNO - OPEN2.0 | pagina 54
Open 2.0
EN
Insert the motor unit.
4
Guide the rear block inside the rail by a few
centimetres.
Insert the block into the rail profile.
Note: the sign indicates the bottom side!
Position the belt around the pulley.
7
Once the slot has been found, insert and tighten
the screw of the previously-removed block.
5
Push the motor unit all the way into the rail,
holding back the belt. See next step for correct
position.
8
Correct mounting position:
1: the motor is on the bottom of the rail;
2: the belt is ON THE OUTSIDE of the motor cable.
9
1
2
32
Make sure the 2 motor power wires are positioned
with the correct polarity.
6
-0V +24V
To Next Page
Loading...