Scrigno Open 2.0 - Page 55

R1387 DCM2461/SCRIGNO - OPEN2.0 | pagina 55
Open 2.0
EN
IMPORTANT: Do not use the endstop!
!
Fixing the rod to the rail: by slightly pulling out the
cable inside, the space is created to insert the screw
in the appropriate hole.
Fit the 2 hangers on the rail.
12
2x
10
Make sure that the motor is positioned at the bottom
of the frame, and tighten the 3 self-tapping screws
on the rail.
A
11
Rail
Fastening rod
Hanger transit area: caution! DO NOT DRILL HERE!
Rod screw
!
Align the pulley bracket and the slot end.
14
Tighten the 2 self-tapping screws.
15
Loosen bolt (A).
Fit the driven pulley in the rail.
13