24 EN
Drill your concrete substrate and install your 4 metal or chemical anchors dowels to secure your engine
support plate.
Skip all power cables and accessories.
Make sure using a level tool that the motor mouting plate is level.
Position your engine and bolt it with 2 screws provided.
Nylon racks fixation :
Nylon rack are producing by thermoplastic material with steel insert and adapted to the gates of a weight
of 400 Kg maximum. They are easily mounted on the gate, by simple screwing. We provide you with the self-
drilling screws.
If your gate conception does not allow direct mounting racks, you must create a new support base :
To place the first rack, put it down respecting a 2 mm space between the engine’s toothed wheel and the rack
as indicated on the scheme bellow :
2 MM
ENGINE’S TOOTHED
WHEEL
Then draw your markings to screw self-drilling screw as shown below :
-
Remarked
Cra
yon
C
ray
on
Remarked
Piercing to
effectuate
Never pierce
at the bottom
Haut
Bottom
(Figure 4)
Piercing
1.5 to 2 mm (cm)
(Figure 5)
Remarked
Cra
yon
C
ray
on
Remarked
Piercing to
effectuate
Never pierce
at the bottom
Haut
Bottom
(Figure 4)
Piercing
1.5 to 2 mm (cm)
(Figure 5)
drawing
points
drawing
points
bottom
top
Screw the self-drilling screw up the slot of your rack :
Support base
Drive
gear
Maintain
level tool
Draws
To Next Page
Loading...
