SD CodeFree - Meter Setup and Configuration

SD CodeFree™ BLOOD GLUCOSE MONITORING SYSTEM
19
Understanding Your New System
10. Meter Set up
STEP-1 : Setting the Audible Beep
1. In Strip Stand-by Display, if you press the
ON/OFF button during 3 seconds, the
display for setting the beep will appear, the
rst step of the setting mode.
2. Set the beep mode on or o by pressing
either the left or the right button and then
selecting the preferred feature by pressing
the ON/OFF button. If you select the beep
on feature, a ‘beep’ sound is made at the
same time; otherwise, if you select the
beep o feature, no sound is made.
[ During 3 sec. ]
[ Left or right
button ]
[ ON/OFF
button ]