SD CodeFree™ BLOOD GLUCOSE MONITORING SYSTEM
17
Understanding Your New System
9. Inserting the Battery
Inserting and replacing the Battery
Your meter is shipped with one 3V battery
type CR2032 that needs to be inserted before
testing. The battery that comes with your
meter can be found in the mesh pocket of your
carrying case. Battery life will vary depending
on usage, so always keep a spare on hand. The
meter saves battery power by automatically
turning o after 1 minute without inserting a
test strip or 3 minutes with a test strip, from
non-use. If the meter does automatically shut
o, all tests in memory are saved.
STEP-1: Push the recessed plastic tab of the
battery compartment forward to ip and open
the battery door.
To Next Page
Loading...
