EasyManuals Logo

Sea-doo GTX 4-TEC User Manual

Sea-doo GTX 4-TEC
138 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #70 background imageLoading...
Page #70 background image
Safety Lanyard and
Engine Start/Stop Button
Position shift lever in neutral. Ensure
that both switches operate properly.
Start engine and stop it using each
switch individually.
WARNING
Should the safety lanyard cap is
loose or fail to remain on its post,
replace it immediately in order to
avoid unsafe use.
Water Flow in Exhaust
Manifold (only when
temperature is below or
close to freezing point)
In Northern areas, if watercraft is to
be used when temperature is be lo w or
close to freezing p oint (0°C (32°F)) or if
waterc raft was left unu sed while tem -
perature was below or close to freez-
ingpoint,watermaybefrozeninthe
supply hose going to the exhaust man-
ifold. This could cause exhaust cool-
ing system overheating. To ensure it
is properly working, do the following
prior to using the watercra ft:
The procedure is to be performed
with watercraft out of water.
Connect a garden hose to the flush-
ing connector at jet pump.
Perform the flushing operation as
explained in POST-OPERATION
CARE.
Ensure water flows out of jet pump.
Otherwise, water is frozen in s up-
ply hose and restricts water flow.
Do not opera te the watercraft in
this condition.
NOTE: Pa y attention that som e wate r
will also flow out of exhaust outlet.
Make sure water is effec tively flowing
out of jet pump.
CAUTION: Operating watercraft
with frozen water in supply hose
might lead to engine components
damage.
NOTE: When water freezes, no dam-
age to engine components will occur
as water expands but it may cause
damage by preventing full flow of c ool-
ing wate r.
Eitherwaituntilicemeltorpour
some hot water on supply hose go-
ing to exhaust manifold. Then, per-
form th e f lushing ope ra tio n again
to make sure water properly flows
out of jet pump. If you need assis-
tance, refer to a n authorized S ea-
Doo dealer.
WARNING
Do not use any electrical heating
device to heat the hose. Electrical
devices may generate sparks that
would ignite fuel vapors that might
be present in the bilge causing a
re or an explosion.
Ensure to d rain bilge if water is
present.
68
______________________

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sea-doo GTX 4-TEC and is the answer not in the manual?

Sea-doo GTX 4-TEC Specifications

General IconGeneral
ManufacturerSea-Doo
ModelGTX 4-TEC
CategoryPersonal Watercraft
Displacement1494 cc
Horsepower155 hp
Fuel TypeGasoline
Seating Capacity3
Hull MaterialFiberglass
Engine Type4-stroke
Fuel Capacity15.9 gallons
Width48 in

Related product manuals