105
Pre-Season Preparation Chart
NOTE: It is highly recommended that an authorized SEA-DOO dealer perform
the annual safety inspection and factory campaigns in addition to the pre-season
preparation all at the same time.
➀ Before installing new spark plugs, it is suggested to burn the excess BOMBARDIER
LUBE lubricant or equivalent by starting the engine using the old spark plugs.
➁ Safety item covered in the annual safety inspection.
OPERATIONS
TO BE
PERFORMED
BY
GENERAL
Lubrication/corrosion protection Operator
Spark plug replacement ➀ Dealer
ENGINE
Exhaust system condition (fasteners, hoses etc.) Dealer
RAVE valve cleaning (if so equipped)Dealer
Counterbalance shaft oil level (if so equipped)Dealer
TDC setting (RFI and DI models)Dealer
Air compressor, visual condition of hoses. Check for leaks
(DI models)
CAUTION: Main hose between compressor and fuel rail may
be hot.
Dealer
COOLING SYSTEM Inspection of cooling system hoses and components Dealer
FUEL SYSTEM
Carburetor adjustment (carburetor-equipped models)Dealer
Throttle ➁ and choke (carburetor-equipped models) cable
inspection/adjustment
Dealer
Fuel filter replacement (except RFI models)Dealer
Fuel injection sensors verification (RFI and DI models)Dealer
Fuel system; check valves, lines, fasteners, pressurization ➁ Dealer
Direct injector, check for leakage (DI models) Dealer
Filler neck, fuel tank and fuel cap condition ➁ Dealer
Flame arrester inspection (except 947 engines) ➁ Dealer
Fuel tank straps Operator
Refill fuel tank
LUBRICATION
SYSTEM
Oil injection pump adjustment and bleeding Dealer
Oil filter replacement Dealer
Oil injection reservoir straps Operator
Oil injection reservoir filling Operator
ELECTRICAL
SYSTEM
Battery condition/charging and reinstallation Dealer
Battery, starter connections and routing ➁ Dealer
Monitoring beeper Dealer
Digitally encoded security system Dealer
STEERING SYSTEM Steering system adjustment/inspection ➁ Dealer
O.P.A.S. SYSTEM
Check O.P.A.S. system condition including filter. Replace all 8
square rings
Dealer
PROPULSION
SYSTEM
Shifter system condition and cable adjustment (if so equipped)Dealer
VTS (Variable Trim System, if so equipped)Dealer
Propulsion system inspection Dealer
Jet pump oil replacement Dealer
HULL AND BODY Inspection of bailer pick-ups Dealer
smo2002-002a.book Page 105 Monday, July 30, 2001 2:18 PM
To Next Page
Loading...
Need help?
General