44
Display Priorities
The clock, (clock/compass, if so
equipped) is the default display mode.
The default display is the one that ap-
pears when the information center is
first activated or displayed back after
an alternate display was chosen.
The tachometer, speedometer and
chronometer, are the only other modes
that may be chosen to replace the de-
fault display. When one of these is se-
lected, it will become the default dis-
play until it is changed again.
When another display mode is chosen,
the default display will be displayed
back after 4 seconds.
As a self test, all LCD segments and the
LED will turn on for 3 seconds each time
the information center is activated.
In the event of a warning message, the
message will blink and override the
units display.
If more than one warning message oc-
curs, the blinking messages will scroll
every 4 seconds.
Other Functions
The following describes how to select
other available functions.
Language Option
While in the clock/compass mode:
1. Press and hold for 2 seconds
1. Repeatedly press
1. Press to end
English/Metric System
Allows to display the units in the met-
ric system or in the SAE English sys-
tem.
1. Press TOGETHER and hold for 2 seconds
Clock Adjustment
While in the clock/compass mode:
1. Press TOGETHER and hold for 2 seconds
1. Repeatedly press to adjust HOURS
F00L2B0
1
F00L2BZ
1
F00L2B0
1
F00L2B1
1
F00L2B1
1
F00L2BZ
1
smo2002-002a.book Page 44 Monday, July 30, 2001 2:18 PM
To Next Page
Loading...
Need help?
General