75
Flushing
To flush cooling system, start the en-
gine then immediately open the water
tap.
CAUTION: Never flush a hot engine.
Always start the engine before open-
ing the water tap. Open water tap
immediately after engine is started
to prevent overheating.
Run the engine about 3 minutes at a
fast idle around 3500 RPM.
Ensure water flows out of drain lines
(engine crankcase, engine cylinder and
air compressor (DI models) while flush-
ing. Otherwise, clean the lines.
CAUTION: Never run engine longer
than 5 minutes. Drive line seal has no
cooling when watercraft is out of wa-
ter.
Lubrication
717 and 787 Engines
Spray BOMBARDIER LUBE lubricant
or equivalent, through hole of air intake
silencer keeping engine at fast idle
during one minute.
1. Air intake silencer
2. Pull plug
3. Spray BOMBARDIER LUBE here
947 Engines
Spray BOMBARDIER LUBE lubricant
or equivalent, through hole of air intake
silencer keeping engine at fast idle
during one minute.
1. Air intake silencer
2. Spray BOMBARDIER LUBE here
All Models
Close the water tap then stop the engine.
CAUTION: Always close the water tap
before stopping the engine.
Final Steps
Disconnect the garden hose.
Remove spark plug cables and connect
them on the grounding device.
GTI MODELS
1. Grounding device
WARNING
Components inside engine com-
partment may be hot. Do not touch
any electrical parts or jet pump
area when engine is running.
3
F01F25Y
2
1
WARNING
Always use spark plug cable ground-
ing device when removing spark
plugs.
F02H0ZY
1
2
F01H7CY
1
smo2002-002b.fm Page 75 Monday, August 6, 2001 1:28 PM
To Next Page
Loading...
Need help?
General