To Next PageTo Next Page
Need help?Do you have a question about the Sea Tel 4009-33 and is the answer not in the manual?
Guidelines for selecting the optimal mounting location for the antenna on a ship.
Detailed instructions for installing the Above Decks Equipment (ADE) radome assembly.
Guidance on installing the Antenna Control Unit and other below-decks components.
Procedures for connecting AC power and various data cables to the BDE components.
Lists factory default parameters for the DAC-2202 unit and guidance on optimization.
How to calculate and enter the IF tracking frequency for VSAT systems.
Automatic calculation and setting of Azimuth and Elevation trim offset parameters.
Procedure to manually adjust Azimuth and Elevation for optimal satellite targeting.
Adjusting the Elevation trim offset parameter to correct for alignment errors.
Adjusting the Azimuth trim offset parameter for installation alignment errors.
Calibrating the relative azimuth value to the ship's bow line using HFO.
Physical adjustment of the home flag clamp for accurate bow reference.
Describes automated search patterns initiated when satellite signal is lost.
Programming relative azimuth sectors (zones) for blockage or RF hazard.
Wiring instructions for connecting various satellite modems to the ACU.
Enabling system functions like External AGC, Modem Lock, and Blockage output.
Procedure to adjust SAT SKEW for peak receive signal level.
Adjusting polarity angle for maximum Cross-Pol isolation with network center guidance.
Step-by-step guide for installing the ProgTerm diagnostic software.
Configuring communication settings in ProgTerm for TCP/IP and Serial connections.
Guide for updating the ACU Main PCB firmware using ProgTerm software.
Guide for updating the ACU DVB PCB firmware using ProgTerm software.
Detailed technical specifications for the DAC-2202 Antenna Control Unit.
General