10
• On the “DEPTH AL” screen, the maximum depth alarm setting flashes:
increase the value with the “U” button or decrease with the “D”. Briefly press
the “M” button to confirm.
• The ON/OFF setting for the alarm set for exceeding maximum depth flashes:
Use the U/D buttons to select “ON” or “OFF”, and then briefly press the “M”
button to confirm.
• On the “D TIME” screen the setting for the maximum dive time alarm flashes:
increase the value with the “U” button or decrease with the “D”. Briefly press
the “M” button to confirm.
• The ON/OFF setting for the alarm set for exceeding maximum time flashes:
Use the U/D buttons to select “ON” or “OFF”, and then briefly press the “M”
button to confirm.
• On the “MSST AL” screen, the ON/OFF setting for the alarm for failure to
respect the minimum suggested surface time (MSST) flashes: Use the U/D
buttons to select “ON” or “OFF”, and then briefly press the “M” button to
confirm.
• On the “D MEDIA” screen, the SEA/FRESH setting for use in seawater or
freshwater flashes: Select “SEA” for seawater, or “FRESH” using the U/D
buttons, and then briefly press the “M” button to confirm.
• On the “LOG RATE” screen you set the frequency at which dive data is
saved: either every 1 second or every 2 seconds. Use the U/D buttons to
select 1 or 2, and then briefly press the “M” button to confirm.
• To exit SET “DIVE”, press the “M” button.
To Next Page
Loading...
