28
Limited-Speed Operation
The 4-TEC models also offers a special
safety lanyard — the SEA-DOO Learn-
ing Key
TM
— which electronically limits
the speed of the watercraft to approx-
imately 55 km/h (35 MPH) therefore
enabling first time users and less expe-
rienced operators to learn how to oper-
ate the watercraft while gaining the
necessary confidence and control.
2) Handlebar
The handlebar controls the direction of
the watercraft. Turning the handlebar
to the right steers the watercraft to the
right and inversely.
3) Throttle Lever
When the throttle lever is squeezed,
the watercraft accelerates. When fully
released, engine automatically slows
down to idle speed and watercraft is
gradually stopped by water drag.
4) Engine Start/Stop
Button
To start engine, depress and hold the
start/stop button. Release immediate-
ly after engine is started.
To stop engine depress the start/stop
button. When stopped, disconnect safe-
ty lanyard from the post. It is suggested
to release throttle lever first.
1. Engine start/stop button
5) Shift Lever
A push-pull lever:
– forward
– neutral
– reverse.
WARNING
Check handlebar and correspond-
ing steering nozzle and side vanes
operation before starting. Never
turn handlebar while someone is
nearby rear of watercraft. Keep
away from steering moving parts
(nozzle, side vanes, linkage etc.)
F00L2SY
WARNING
Directional control is reduced when
the throttle is released or when en-
gine is off.
WARNING
Shift lever should only be used
when the engine is idling and craft
is completely stopped. Do not use
as a grab handle.
1
F18L09Y
smo2002-003_a.book Page 28 Friday, October 12, 2001 2:04 PM
To Next Page
Loading...
Need help?
General
