70
Refer to an authorized Sea-Doo dealer
if an adjustment is necessary.
Vacuum Bailer Pick-Ups
They are located each side of the drive
shaft tunnel.
Two pick-ups use a low pressure area in
the jet pump to siphon the water out of
the bilge when the engine is operating.
Inspect each pick-up screen for ob-
structions, clean as necessary.
TYPICAL
1. Vacuum bailer pick-ups
Fuses
If an electrical problem occurs, check
the fuses. If a fuse is burnt, replace by
one of the same rating.
1. Fuse
2. Check if melted
3. Ampere rating
Follow procedures below.
Fuses can be found on the MPEM in en-
gine compartment and one can be find
in front of fuel tank.
NOTE: To understand the acronyms
used here, refer to ABBREVIATIONS
USED IN THIS MANUAL section at the
end of the guide.
WARNING
Ensure the handlebar and jet pump
nozzle operate freely from side to
side and are not stressing the steer-
ing cable or brackets. Never turn
handlebar while someone is near-
by rear of watercraft. Keep away
from steering moving parts (noz-
zle, side vanes, linkage etc.).
F18L11Y
1
WARNING
Do not use a higher rated fuse as
this can cause severe damage. If a
fuse has burnt out, source of mal-
function should be determined and
corrected before restarting. See an
authorized Sea-Doo dealer for ser-
vicing.
A15E0KZ
1
2
3
smo2002-003b.fm Page 70 Wednesday, December 12, 2001 9:55 AM
To Next Page
Loading...
Need help?
General
