Seaga INF4C - Motor Count Display; Specific Motor Test

45Revision 2.EL950 1.3.1074C 18.6
STEP DISPLAY
1. Press Service Mode Buon Motor Count or Error Code **
2. Press 6 for Password (Advanced Features) Menu Password
3. Enter Password (default 2314) Advanced Features
4. Press 7 for Pair menu Pair - - - *-Exit
5. Enter the rst motor number Pair 013 to --- *-Exit #-Add
6. Press # and enter the 2nd motor number Pair 013 to 015 *-Exit #-Save
7. Press * two mes to add another pair of motors or Pair - - - *-Exit #-Save
8. Press * ve mes to exit to Sales Mode 0.00
STEP DISPLAY
1. Press Service Mode Buon Motor Count or Error Code **
2. Press 6 for Password (Advanced Features) Menu Password
3. Enter Password (default 2314) Advanced Features
4. Press 8 for Degrees menu Degrees - - - *-Exit 8-Edit
5. Press 8 to Edit Toggle between F and C
6. Press # to save or * to Exit Degrees - - - *-Exit #-Save
7. Press * ve mes to exit to Sales Mode 0.00
STEP DISPLAY
1. Press Service Mode Buon Motor Count or Error Code **
2. Press 7 for Motor count display menu Motors (Count Flashes)
3. Press * to exit to Sales Mode 0.00
STEP DISPLAY
1. Press Service Mode Buon Motor Count or Error Code **
2. Press 8 for Selecon motor test menu Selecon: --
3. Enter selecon to test and wait Selecon: (Current Selecon) *-Delete
4. Repeat for any other selecons or Selecon: (New Selecon) *-Delete
8. Press * to exit to Sales Mode 0.00
PAIR
This funcon allows two adjacent motors to run at the same me so that large, wide items can be
accommodated. A coil and rail change is also required. See Combining Selecons secon of this manual for
more informaon.
DEGREES
This funcon allows you to change from Fahrenheit to Celsius.
MOTORS
This funcon displays the motor count. It is a useful, quick diagnosc tool in case of selecon failure and
can point out a motor issue if the count is not correct.
SELECTION
This funcon tests the motor on one specied selecon.