48Revision 2.EL950 1.3.1074C 18.6
Bill Val Comm VMC does not have communicaon with the bill
validator.
Check MDB Harness to validator. Check for power on
validator.
Bill Val Stack Full The bill validator has reported that the stacker is full of
bills.
Check bill stacker box for bills. See validator service
manual.
Bill Val Motor Err The bill validator reports that a validator motor error
has occurred.
See validator service manual.
Bill Val Jam The bill validator reports a bill is stuck in the bill path. Check validator bill path for bills. See validator service
manual.
Bill Val Stack Open The bill validator is reporng a bill box is open or not
installed.
Check bill stacker box for open lid. See validator
service manual.
Bill Val Sensor Err The bill validator reports a sensor error. See validator service manual.
Bill Val Comm VMC does not have communicaon with the bill
validator.
Check MDB Harness to validator. Check for power on
validator.
Bill Val Stack Full The bill validator has reported that the stacker is full of
bills.
Check bill stacker box for bills. See validator service
manual.
Bill Val Motor Err The bill validator reports that a validator motor error
has occurred.
See validator service manual.
Bill Val Jam The bill validator reports a bill is stuck in the bill path. Check validator bill path for bills. See validator service
manual.
Bill Val Stack Open The bill validator is reporng a bill box is open or not
installed.
Check bill stacker box for open lid. See validator
service manual.
Bill Val Sensor Err The bill validator reports a sensor error. See validator service manual.
Card Reader 1 and 2 Errors
Card RDR1 or 2 Comm VMC does not have communicaon with the
card reader.
Check MDB Harness to card reader. Check for
power on card reader.
Card RDR1 or 2 Err The card reader reports an error See card reader service manual.
NOTE: Errors are cleared aer the problem detected has been resolved.