Seaga Quick Break Combo QB218 - Motor Errors; Temperature Sensor Errors; Vend Sensor Errors; Coin Changer Errors

65QB218 6.1.2019 vers 1.0
Temperature Sensor Errors
Error Message Descripon Possible Soluons
Refrig Sensor #
Open
A temperature sensor or harness is
considered to have an open electrical
connecon. Where # is the sensor number.
Check sensor and sensor harness for open
connecons. Check for sensor readings. Replace
sensor if necessary.
Refrig Sensor #
Short
A temperature sensor or harness is
considered to have an electrical short.
Where # is the sensor number.
Check sensor and sensor harness for shorted
connecons. Replace if necessary.
Refrig Health Safety
The cabinet temperature and me limit
sengs have been exceeded.
Check sensor readings and sensor harness for
shorted connecons. Check for sensor readings.
Replace sensor if necessary.
Vend Sensor Errors
Error Message Descripon Possible Soluons
Opcal Sensor
Error
Not Applicable NA
Coin Changer Errors
Error Message Descripon Possible Soluons
Coin Mech Comm
VMC does not have communicaon with the
coin changer.
Check MDB Harness to changer. Check for power
on changer. See changer service manual.
Coin Mech Tube
Sns
The coin changer has reported a tube sensor
error.
See changer service manual.
Coin Mech Inlet
The coin changer has reported an acceptor
blockage.
Check changer tubes. See changer service manual.
Coin Mech Tube
Jam
The coin changer has reported a tube payout
error.
Check changer tubes. See changer service manual.
Coin Mech ROM
The coin changer has reported a program
memory error.
See changer service manual.
Coin Mech Excess
Esc
The coin changer has reported that a large
number of coin escrow requests have
occurred.
Check changer escrow lever posion.
Coin Mech Coin
Jam
The coin changer has reported that a coin is
jammed in the coin path.
Check changer coin path. See changer service
manual.
Coin Mech Low
Accept
The VMC has seen a low acceptance rate on
coins.
Review inserted coins. See changer service
manual.
Coin Mech Accpt
Disc
The coin changer has reported that the coin
validaon acceptor is disconnected.
Re-connect the coin changer’s acceptor. See
changer service manual.
Coin Mech Route
Err
The coin changer reported that a coin did
not follow the correct path.
Check changer coin path. See changer service
manual.