Product Manual - Hawk 1 Family SCSI-2 (Volume 1), Rev. D
______________________________________________________________________________________
11.3 SCSI interface commands supported
Table 11.3-1 following lists the SCSI interface commands that are supported in the SCSI-1 and SCSI-2
modes of the drive. Hawk 1 Family drives can be changed back and forth between SCSI-1 and SCSI-2
modes using the Change Definition Command. OEM standard drives are shipped set to operate in SCSI-2
mode.
Table 11.3-1. Commands supported by Hawk 1 family drives
Com’d Supported by:
Code SCSI-1 SCSI-2 Command Name
00h Y Y Test unit ready
01h Y Y Rezero unit
03h Y Y Request sense
Y Y Extended sense
Y Y Field pointer bytes
N N Actual retry count bytes
04h Y Y Format unit [1]
07h Y Y Reassign blocks
08h Y Y Read
0Ah Y Y Write
0Bh Y Y Seek
12h Y Y Inquiry
N Y Vital product data page
N Y Unit serial number page
N Y Implemented operating def. page
N Y Firmware numbers page
N Y Date code page
N Y Jumper settings page
15h Y Y Mode select (same pages as mode
sense command see below)
16h Y Y Reserve
Y Y 3rd parity reserve
N N Extent reservation
17h Y Y Release
18h N N Copy
1Ah Y Y Mode sense
Y Y Unit attention page (00h)
Y Y Byte 2 bit 4 (unit attn bit)
Y Y Byte 2 bit 5 (DEID bit
Y Y Error recovery page (01h)
Y Y Disconnect/reconnect
Control page (02h)
Y Y Format page (03h)
Y Y Rigid disc drive geometry page (04h)
N Y Verify error recovery page (07h)
Y Y Caching parameters page (08h)
N Y Control mode page (0Ah)
N Y Notch and Partition Page (0C) (Media Zones)
[1] Hawk 1 can format to any even number of bytes per sector from 256 to 4096.
42
To Next Page
Loading...
