Product Manual - Hawk 1 Family SCSI-2 (Volume 1), Rev. D
_____________________________________________________________________________________
1.0 Scope
This specification describes the Seagate Technology, Inc. Model Hawk 1 Family Disc Drives. These high
capacity, high performance disc drive products have been designed to support the Small Computer Sys-
tems Interface (SCSI) and are classified as “Intelligent” peripherals. The Model Hawk 1 Family is function-
ally compatible to a subset of the Seagate SCSI-2 Interface Specification 77738479, and the ANSI SCSI-2
standard. The Hawk 1 Family also provides Level 2 conformance (highest level) with the ANSI SCSI-1
standard. Details of the Hawk 1 Family drive SCSI implementation are provided in Section 11 of this speci-
fication, (Vol. 1) and in the SCSI-2 Interface Product Manual P/N 77738479 (Vol. 2; Ver. 2).
The Hawk 1 family of drives consists of the ST11200N/ND/NC, ST1980N/ND/NC, ST1950N and ST1830N
drives.
The Hawk 1 Family products will be referred to as “the drive” from this point on unless reference to individual
models are necessary.
The drive printed circuit board is referred to as a PCB.
* 50 pin SCSI I/O and 4 pin DC power connector shown. "NC" models have one 80 pin connector and no
separate DC power connector.
Figure 1-1. Hawk 1 N/ND family drive
SEAGATE
*
1
To Next Page
Loading...
