Seagate ST157N - 2.3 ST125 N;138 N;157 N SCSI Commands

• Sector lnterteave
•
Enable/disable error recovery
• Enabllng/dlsabllng reporting of recovered error status
• Enabllng/dlsabllng of reporting usage and error counter overflow
2.2.1 SCSI Bus Address
Jumpers are provided on the drive for selecting the SCSI bus address.
The microprocessor accesses this Information at power-on. The address
jumpers are accessed only during the power-on sequence. H the SCSI
address Is changed, the drive must be powered off and on.
2.3 ST125N/138N/157N SCSI Commands
The commands shown In the Command Summary figure that follows are
supported by the ST125N/138N/157N. Refer to the Seagate SCSI /nter-
faet1 Manua/for a detailed discussion of the SCSI Interface.
ST125N/138N/157N Product Manual, Rev. C 15