Seagull Models Arising Star - Page 4

4
Arising Star. Instruction Manual.
 4) Once the epoxy has cured, trial fit
both wing halves together. The centre ribs
should fit together flush with no gaps. If gaps do
exist, use 220 grit sandpaper and sand down
the high spots on the root ribs and the wing
joiner until a proper fit is achieved. The correct
amount of dihedral is ready-built into the wings.
With one wing half laid flat on the table, the
other wing tip should be off the table surface.
If this needs to be adjusted, you may do so by
sanding small amounts from the centre ribs or
dihedral brace.
 5) Carefully apply masking tape around
the top and bottom edge of the root rib of each
wing half to protect them from damage caused
by epoxy.
 1) Install the rubber grommets and brass
collets onto the aileron servo. Test fit the servo
into the aileron servo mount.
Because the size of servos differ, you
may need to adjust the size of the precut
opening in the mount. The notch in the sides
of the mount allow the servo lead to pass
through.
 2) Remove the aileron servo. Place the
mount onto the wing, aligning the cutout in the
mount with the cutout in the wing. The two
notches in the mount should face the leading
edge of the wing.
 3) While holding the servo mount firmly
in place, trace around it using a pen.
 8) Peel off the backing from the self
adhesive covering strip. Apply the strip to the
center section of the wing starting from the
bottom trailing edge. Wrap the strip all the way
around the wing until it meets the trailing edge
again. Trim off any excess strip.
 6) Mix a generous amount of 30 minute
epoxy. Coat the exposed half of the dihedral
brace, and the remaining wing joiner box and
both root ribs with epoxy. Slide the two wing
halves together and carefully align them at the
leading and trailing edges. Wipe away any
excess epoxy using paper towels. Use mask-
ing tape wrapped around the center section to
hold the halves in place until the epoxy cures.
 7) When the epoxy has cured, carefully
remove the masking tape from the wing.
INSTALLING THE AILERON SERVO MOUNT.
Epoxy.
Masking tape.
Glue attached.
Epoxy attach.