Seagull Models RACER DELTA 40-46 User Manual

1
ASSEMBLY MANUAL
RACER DELTA 40-46
Code: SEA307
Specications:
Wingspan---------------39.0 in (98.5 cm).
Wing area---------------641.1 sq.in ( 41.4 sq.dm).
Weight-------------------4.4-4.8 lbs (2.0-2.2 kg).
Length-------------------29.3 in (74.3 cm).
Engine-------------------0.40-0.46 cu.in 2 stroke.
Radio--------------------4 channels with 6 servos.
“ Graphics and specications may change without notice ” .

Seagull Models RACER DELTA 40-46 Specifications

General

Brand	Seagull Models
Model	RACER DELTA 40-46
Category	Toy
Language	English

Summary

Kit Contents

Assembly Preparation

Required Items and Tools

Lists of additional items and tools needed for assembly.

Wing and Aileron Assembly

Hinging Ailerons

Securely attaching aileron hinges to wing panels.

Aileron Control Horn and Servos

Installing aileron control horns, servos, and pushrods.

Landing Gear Installation

Main Landing Gear

Attaching the main landing gear assembly to the fuselage.

Tail Wheel Mounting

Securing the tail wheel assembly to the fuselage.

Rudder Assembly and Installation

Hinging the Rudder

Attaching rudder hinges using similar methods as ailerons.

Rudder Control Horn and Servos

Installing rudder control horn and servos.

Vertical Stabilizer Installation

Install Vertical Stabilizer

Aligning and epoxying the vertical stabilizer.

Rudder Pushrod Installation

Connecting the rudder servo to the rudder via pushrod.

Fuel System Installation

Fuel Tank Stopper Assembly

Assembling the fuel tank stopper with pick-up and vent tubes.

Fuel Tank Installation

Securing the fuel tank inside the fuselage.

Engine and Throttle Installation

Engine Mount and Engine

Attaching the engine mount and securing the engine.

Throttle Servo Arm

Installing the servo arm for throttle control.

Cowling Installation

Fit and Trim Cowling

Trimming the cowling for a proper fit over the engine.

Cowling Mounting

Drilling holes and securing the cowling to the fuselage.

Electric Power System Installation

Motor Box, Motor, and ESC

Installing the motor box, motor, and speed controller.

Final Assembly

Spinner Installation

Mounting the spinner backplate, propeller, and cone.

Pilot, Windshield, Battery, Receiver

Installing pilot, windshield, battery, and receiver.

Finishing and Balancing

Apply Decals

Applying decals for the final appearance of the model.

Airplane Balancing

Achieving the correct center of gravity for safe flight.

Flight Control Setup

Control Throws Configuration

Setting the correct range of movement for control surfaces.

Pre-Flight Procedures

Flight Preparation Checks

Checking control surface operation and direction.

Preflight Safety Checks

Performing essential safety and component checks before flying.