Seagull Models ZERO MS:123 - Plastic Parts Installation

33
www.seagullmodels.com
2
3
C/A glue.
M2x6mm.
5) Install the canopy and secure it with M2x6mm
screws.
- Apply a bead of canopy glue around the inside
edge of the canopy . Position the canopy onto
the hatch. Use tape to hold the canopy secure
until the glue fully cures.
4) Position the canopy onto the fuselage. Trace
around the canopy and onto the fuselage using
a felt-tipped pen.
1
Epoxy.
INSTALL THE PLASTIC PARTS.
C/A glue.
C/A glue.
4