Seakeeper 6 - Startup, Stabilization, and Shutdown


OPERATION
MANUAL
Product: Document #: Rev: Page:
SEAKEEPER 6 90403 1 6 of 6
Section 2: SYSTEM OPERATION


8) The alarm history page shows what alarms have occurred in the past and the
associated run hours. The scroll bar is used to move up and down through the list.
2.2 Start-up
1) Make sure AC and DC power are available.
2) Turn on the boat’s DC circuit breaker that supplies power to the Seakeeper.
3) Turn on the boat’s AC circuit breaker that supplies power to the Motor Drive Box.
4) In most cases, the seawater pump will be wired to turn on when the Seakeeper or Motor
Drive Box is turned on. However, in some cases the seawater pump is on a separate
AC or DC circuit breaker and it is necessary to turn it on.
5) When the DC power is turned on the Display will initialize and the Home screen will
appear.
To turn the Seakeeper on, press the On/Off button, the button will turn blue. The
progress bar will appear and indicate how soon the Seakeeper will be available for
stabilization. When the Seakeeper is initialized and up to minimum operating speed the
stabilize button will appear. At this point, the Seakeeper is available for stabilization.