SEAL 62Pro - Material Specifications; Machine Specifications

16 User Manual 62Pro
3.3 Material specifications
Maximum width Metric American
Process up to 50°C (122 °F) 1575 mm 62 in.
Process up to 125°C (257 °F) 1524 mm 60 in.
Maximum roll diameter
Material unwind (top and upper unwind) 200 mm 8 in.
Material unwind (top unwind only) 305 mm 1 ft.
Material unwind (bottom unwind) 305 mm 1 ft.
Release liner wind-up 180 mm 6 in.
Maximum panel thickness 38 mm 1.5 in.
Roll core inside diameter 76.2 mm 3 in.
3.4 Machine specifications
Power supply requirement
Europe 3N/PE 230VAC +/- 10%, 50/60Hz, 16A
USA 2W+G 230VAC +/- 10%, 50/60Hz, 35A
For the correct supply voltage version refer to the identification label on the machine.
Standard number of shaft positions
Material unwind 1 (auto-grip)
Release liner wind-up 1 (auto-grip)
Unwind/wind-up 3 (auto-grip)
Optional features
Easy-feed table
Slitters
Extra plot unwind for 2” and 3” cores (only in combination with standard in-feed table)
Cooling device
Nip setting 0–40 mm 0–1
9
/
16
in.
Pressure 1–2.5 N/mm 5.71–14.28 lbf/in.
Process speed
Maximum 6 m/min 20 ft/min
Slow mode 0.6 m/min 2 ft/min
Maximum roller temperature 130 °C 266 °F
Noise level <70 dB(A)