INSTRUCTIONS FOR:
DOUBLE LEVER GREASE GUN
MODEL NO: AK4403
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING! Ensure Health & Safety, local authority and general workshop practice regulations are adhered to when using this equipment.
9 Familiarise yourself with the application and the limitations of the grease gun, as well as the potential hazards.
9 Keep the work area clean, uncluttered and ensure there is adequate lighting.
9 Keep the grease gun clean for best and safest performance.
9 Check moving parts alignment on a regular basis.
8 DO NOT use the grease gun for any purpose other than that it was designed for.
8 DO NOT operate the grease gun if any parts are damaged or missing, as this may cause failure and/or personal injury.
9 When not in use store in a safe, dry, childproof location.
WARNING! Always wear approved eye protection when operating this gun.
2. INTRODUCTION
Robust, double arm grease gun with aluminium die-cast head. Uses screw type grease cartridges using vacuum suction to ensure full utilization
of grease cartridge as well as eliminating priming issues associated with conventional grease guns. Features a protective cap for hose storage
preventing contamination. 1/8” BSPT thread and supplied with adaptor to t most screw type cartridges on the market, including model numbers:
SCS107 & SCS108. Zinc plated lever handles with rubber ergonomic grips. Fitted with minimal wearing parts to ensure prolonged life and
supplied with 300mm (12”) delivery hose and 4-jaw coupler.
3. SPECIFICATION
Model no: ................................................................. AK4403
Delivery pressure: ......................................................7500psi
Delivery per stroke: ..................................................... 0.8cm²
4. OPERATION
4.1. Remove cap from cartridge and screw into grease gun body, (select grease gun cartridge adaptor as appropriate).
4.2. Work handles to displace air from delivery tube.
AK4403 | Issue 1 01/02/16
Original Language Version
© Jack Sealey Limited
Refer to
Instruction
Manual
Wear eye
Protection
To Next Page
Need help?
General
