54 Cockpit
Selecting a memory
To change from one memory to another, briefly press button
A
⇒ Fig. 41 ⇒ page 51 on the windscreen wiper lever or the
OK
button on
the multifunction steering wheel ⇒ Fig. 42 ⇒ page 51 while the ignition
is switched on.
Resetting a memory
Select the memory where you wish to erase the values.
Hold down button
A
on the windscreen wiper lever or the
OK
button
on the multifunction steering wheel* for at least two seconds.
The trip memory 1 collects the travel and consumption data from the mo-
ment the ignition is switched on until it is switched off. If the journey is con-
tinued within two hours of switching off the ignition, the new values will be
added to the existing trip recorder memory. The memory will automatically
be deleted if the journey is interrupted for more than 2 hours.
Total memory 2 collects the trip data for any number of individual journeys
(even if the ignition is switched off for longer than two hours) up to a total of
19 hours and 59 minutes travel time or 1,999 km. The memory will automat-
ically be deleted if one of the named values is reached.
On-screen display
The following data can be viewed on the multifunction display using the
rocker switch
B
⇒ Fig. 41 ⇒ page 51 on the windscreen wiper lever or by
pressing button
or
⇒ Fig. 42 on the multifunction steering wheel*.
● Distance
● Average speed
● Driving speed
● Speed warning at --- km/h (mph)
● Journey duration
● Current fuel consumption
● Average fuel consumption
–
–
–
● Operating range
● Outside temperature
Distance travelled in km (miles)
The display shows the distance travelled since the ignition was switched on.
The maximum display value in both memories is 1,999 km (miles). The
memory will automatically be deleted once this value has been reached.
Average speed in km/h (mph)
After starting the ignition, the average speed will be shown after a distance
of approximately 100 metres has been travelled. Until then dashes will ap-
pear in the display. The display will be updated every five seconds while the
vehicle is in motion.
km/h (mph) - Driving speed
Driving speed is digitally shown in the display.
Speed warning at --- km/h (mph)
This function may help you to keep within the speed limits. Press the
OK
button on the windscreen wiper lever
A
or the multifunction steering
wheel* to select the current speed. The instrument panel display gives the
selected speed, for example, Speed warning 120 km/h. You have five sec-
onds to reset the speed between 30 km/h (18 mph) and 250 km/h (155
mph) using rocker switch
B
or buttons
or
on the multifunction steer-
ing wheel*. Press the
OK
button or wait five seconds until the speed is stor-
ed and the warning is activated. If the set speed is exceeded, an audible
warning is heard and a warning message is displayed until the speed is re-
duced to at least 4 km/h (2 mph) below the stored speed. The function is
switched off by pressing the
OK
button again. Speed warning --- km/h
(miles) is now displayed on the instrument panel.
Duration in h and min
The display shows the amount of time which has elapsed since the ignition
was switched on.
To Next Page
Loading...
