55Cockpit
The maximum display value in both memories is 19 hours and 59 minutes.
The memory will automatically be deleted once this value has been
reached.
Current fuel consumption in l/100 km or l/hour
The display will show the current fuel consumption in litres/100 km whilst
the vehicle is in motion or in litres/hour when the vehicle is in a stationary
position with the engine running.
Using this display you can see how your driving style affects fuel consump-
tion ⇒ page 144.
Average fuel consumption in l/100 km
The average fuel consumption will be shown after a distance of approxi-
mately 100 metres has been travelled. Until then dashes will appear in the
display. The display will be updated every five seconds while the vehicle is
in motion. The amount of fuel used will not be shown.
Km (miles) - Fuel range
The fuel range is calculated using the figures for tank content and current
fuel consumption. It shows how far the vehicle can travel using the same
driving conditions as a reference.
Personal selection of display
The driver can establish which displays are shown on the instrument panel
display as required:
● Select the submenu Multifunction Display Data from the Configuration
menu ⇒ page 56.
● The displays can be activated or deactivated individually by marking the
required option and pressing the
OK
button on the windscreen wiper lever
or the multifunction steering wheel*.
Outside temperature indicator
The measurement margin ranges from -45 °C (-49 °F) to +58 °C (+136 °F). At
temperatures lower than +4 °C (+39 °F), an “ice crystal symbol” is displayed
and a “warning” is given if the vehicle is moving at more than 20 km/h
(12 mph) (ice warning). This symbol will flash for approximately 10 seconds
and remains lit as long as the outside temperature does not rise above
+4 °C (+39 °F) or +6 °C (+43 °F) if it was already lit.
WARNING
There could be black ice on the road surface even if the “snowflake sym-
bol” is not shown. For this reason you should not rely exclusively on this
display - Risk of accident!
Note
● There are different instrument panels; therefore the multifunction dis-
play may vary.
● When the vehicle is stationary or travelling at very low speeds, the tem-
perature displayed may be slightly higher than the actual outside tempera-
ture as a result of the heat radiated from the engine.
● Vehicles with a multifunction steering wheel* do not have buttons on
the windscreen wiper lever. The multifunction display can only be controlled
from the buttons on the multifunction steering wheel*.
Vehicle status menu
Open Vehicle Condition menu
– Select the option Vehicle status from the main menu: “Main
menu” and press button
OK
on the windscreen wiper lever
A
⇒ Fig. 43. or
– Press button
or
on the multifunction steering wheel*
⇒
Fig. 42 until the Vehicle Status menu is displayed.
Safety Operation Advice Technical specifications
To Next Page
Loading...
