Unlocking and locking112
• Release the switch and then lift it again for one second. This will re-enable
the automatic function.
Sliding/tilting sunroof*
Description
The sliding/tilting sunroof is operated using the rotary knob ⇒ fig. 82. The
rotary knob for sliding the roof open can be adjusted to several different
settings (with click stops). This knob only works when the ignition is switched
on. The rotary knob must be in the position if you want to tilt the roof up
at the rear.
The sunroof will work for about ten minutes after the ignition has been
switched off. However, it is immediately disabled when one of the front doors
is opened.
Opening/Tilting
The sunroof will create less wind noise if it is opened in the
convenience position.
Convenience position
– Turn the control until it engages at position ⇒ fig. 82. The
sunroof will now only open as far as the convenience position
which means there is less wind noise.
Opening completely
– Turn the switch to position and hold it until the sunroof
reaches the desired position. This position can cause more wind
noise.
Tilting open
– Turn the control to position .
0
Fig. 82 Detail of head-
liner: Sliding/tilting
sunroof control
1
2
0
ExeoST_EN.book Seite 112 Freitag, 3. September 2010 11:41 11
To Next Page
Loading...
