Cockpit 87
Safety First Operating Instructions Practical Tips Technical Specifications
• Journey duration
• Distance covered
• Average fuel consumption
• Average speed
The onboard computer can only be operated when the ignition is switched on.
When the ignition is switched on, the display shows the function that was last
selected.
As well as the figures from the onboard computer (1 or 2), the display can also
show information from the navigation system*. Press the Reset button
briefly to switch back and forward between these displays.
Note
• If you keep the Reset button pressed for longer than two seconds, it will
reset the currently displayed figure to zero (for instance average fuel
consumption).
• Faults detected by the auto-check control will be displayed even if the
display is off.
• The information in the memory is lost if the battery is disconnected.
Menu display
Introduction
B
Fig. 61 Windscreen wiper
lever: Menu selection
button
Fig. 62 Display: Main
menu
ExeoST_EN.book Seite 87 Freitag, 3. September 2010 11:41 11
To Next Page
Loading...
