EasyManua.ls Logo

Seat Exeo ST 2011 - Ignition lock

Seat Exeo ST 2011
325 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Driving 173
Safety First Operating Instructions Practical Tips Technical Specifications
The Electronic Stability Programme (ESP) contains the electronic differential
lock (EDL) and the traction control system (TCS). The ESP function works
together with the ABS. If a fault in the ABS occurs, both warning lamps light
up, but if the ESP fails, only the ESP warning lamp lights up.
The ESP is started automatically when the engine is started.
The ESP switch deactivates both TCS and ESP functions. The ESP, in spite of
being deactivated, will always self-connect when necessary if brakes are
being used.
The TCS can be deactivated when in cases where wheel sliding is desirable.
For example:
When driving with snow chains,
when driving in deep snow or on loose surfaces,
when rocking the vehicle backwards and forwards to free it from mud, for
example.
Next, the button should be pressed to reactivate the TCS.
When does the warning lamp switch on or flash?
On switching the ignition on, it lights up for about two seconds to carry
out a function control.
The warning lamp will start flashing when the vehicle is moving if the ESP
or the TCS is activated.
It will light up continuously if there is a malfunction in the ESP.
WARNING
The Electronic Stability Programme (ESP) cannot defy the laws of
physics. This should be kept in mind, particularly on slippery and wet
roads and when towing a trailer.
Always adapt your driving style to suit the condition of the roads and
the traffic situation. Do not let the extra safety afforded by ESP tempt you
into taking any risks when driving, as this can cause accidents.
Please refer to the corresponding warning notes on ESP in page 191,
“Intelligent technology”.
Ignition lock
Ignition key positions
The ignition key is used to start and stop the engine.
Position
The ignition key is inserted in this position. To engage the steering wheel
lock, take out the key and turn the wheel until you hear the pin engage. You
should always engage the steering lock when you leave the vehicle. This will
help to deter thefts .
WARNING (continued)
Fig. 147 Ignition key
positions
A
1
ExeoST_EN.book Seite 173 Freitag, 3. September 2010 11:41 11

Table of Contents

Related product manuals