Cockpit 61
Safety First Operating Instructions Practical Tips Technical Specifications
Rev counter
The rev counter indicates the number of engine revolutions
per minute.
You should select a lower gear if the engine speed drops below 1500 rpm.
The start of the red zone on the dial indicates the maximum engine speed
which may be used when the engine is warm and after it has been run in prop-
erly. However, it is advisable to change up a gear or lift your foot off the accel-
erator before the needle reaches the red zone.
Caution
The rev counter needle ⇒ fig. 39 must only reach the red zone for a short
period, otherwise the engine could be damaged. The start of the red zone on
the dial is different for some engine versions.
For the sake of the environment
Changing up into higher gears early will help you to reduce fuel consumption,
emissions and minimise engine noise.
Digital clock and date
Your vehicle is equipped with a quartz clock.
The time and date are set using the and buttons.
Setting the hour
– Press the button. The hour display will start to flash.
– Use the and buttons to set the hour.
Fig. 39 Detailed view of
the instrument panel: Rev
counter
Fig. 40 Detailed view of
the instrument panel:
Digital clock
+ -
MODE
+ -
ExeoST_EN.book Seite 61 Freitag, 3. September 2010 11:41 11
To Next Page
Loading...
