Chapter 3
5
3 SAFETY AND DANGER INSTRUCTIONS
General
▪ Read the user manual carefully before starting with operation!
▪ Only use the device as intended and described in this user manual!
▪ Always keep the user manual available at site where the device is used!
▪ Keep the user manual for future operation!
▪ In case you sell the device or hand it to someone else, also hand over the user manual!
▪ Please be informed that operation and connection faults are beyond our sphere of influence. So,
understandably, we cannot take over liability for resulting damages.
Marks
Pay attention to the different marks used in this user manual.
See hereafter the explanation of meanings of the used marks.
Warning: Situation that might result in injury or death.
Attention: Situation that might result in damage to the device.
Important notice: Important notice and additional information.
Working with electrical voltage
By handling devices, which are supplied by electrical voltage, the valid VDE-instructions, especially
VDE 0100, VDE 0550 und VDE 0700 have to be considered.
Before opening an instrument, pull off the mains plug (if existing) and make sure that the instrument
is without power supply.
Parts, construction groups or instruments must only be set into operation, in case they are built into
a housing and protected against touching. During installation they have to be without power.
It is only allowed to use tools at the instruments, parts or construction groups, in case it is secured
that the instruments are dropped out and the electric loads which are stored in the construction
groups inside the instrument, are unloaded.
Conducting cables or conductors, which are connected to the instrument, part or construction group,
have to be checked continuously to isolation faults or sites of fractures. By verification of a fault in
the supply cable, the instrument has to be switched-off immediately, until the defect cable has been
exchanged.
Before setting into operation, generally check if the instrument or construction group is suitable for
the field of application. In case of doubts, unconditionally contact specialists, experts or the
manufacturer of the used construction group!
To Next Page
Loading...