Before you really get started ... • 75
Fitting the side covers You need the following fastenings for this assembly
step:
1. Put one threaded plate on each end of the right-
hand side part.
2. Ensure that the bores on the threaded plates and
the bores in the side part are in line over one
another.
3. Put the right-hand cover on the right-hand side
part.
4. Secure the cover in position on the side part using
the two screws at each end.
5. Repeat steps 1. to 4. for the left-hand cover.
6. Set up the weighing platform.
7. Put the black cover caps on the screws.
8 x black 4 x threaded plate
8 x M6 x12
To Next Page
Loading...
