Secure Power SP201 - 2.0 Product Introduction

Secure Power Ltd
User Manual
3
1.0 Safety instruction
1.1 Safety instruction
There are dangerous voltages and high temperature inside the UPS, during the installation, operation
and maintenance please abide by local safety instructions and relative laws, failure to do so may
result in personnel injury or damage to equipment. Safety instructions in this manual are
supplementary the local safety instructions. Secure Power Ltd does not accept any liability caused as
a result of neglecting safety instructions. Please note the following:
Don’t use the UPS when the actual load exceeds the rated load.
Under no circumstances open the UPS. There are high-capacity batteries inside and other electrics
that can cause electric shock. If the UPS requires internal maintenance or battery replacements
contact Secure Power Ltd.
The UPS should be kept in a dry, well-ventilated location, away from any area where the fire hazard
may be acute and out of direct sunlight or other sources of heat.
Should the UPS at any time emit smoke, isolate the power immediately and contact Secure Power Ltd.
1.2 Symbols
The safety symbols cited in this manual are shown in table below, these are used to inform readers of
safety issues that should be followed when carrying out installation, operation and maintenance.
Safety Symbol
Indication
Attention
Static discharge
sensitive
Electric shock
There are three levers of safety grade: Dangerous, Warning and Attention. Shown to the right side of
the safety symbol, as the following:
Dangerous: Indicate risk of serious injury or death or seriously damage the equipment.
Warning： Indicate risk of serious injury or damage the equipment.
Attention： Indicate risk of injury or damage the equipment.