Secure Power Ltd
User Manual
8
Warning:
► Before installing the battery, make sure that UPS and breaker are turned off. Remove all any
metallic objects such as rings, watches and so on before connecting.
► No anti-connection or short circuit between the battery anode and cathode forever. Red cable
connect with battery anode “+” and black cable connect with cathode “-”.
► Use a screwdriver with insulating handle and DO NOT lay the tools or metallic goods on the battery.
Notice:
► When using an external battery, it is best to use external battery cable which matches the
equipment.
► When connecting the load to the UPS, first turn off load and then connect the power cable, then
turn on loads one-by-one.
► Inductance loads such as motor, fluorescent lamps and photocopiers should not be connected to
the UPS, as damage may occur.
► Plug UPS into a socket with over-current protection, connected with a ground wire.
► The UPS is likely to have output voltage no matter whether the power input cable is plugged into
the mains input socket. If you wish the UPS to have no output, first break off the switch and then
cancel the mains.
► When connect to a laser printer, select the capacity of UPS according to the UPS start power
because the start up power is higher.
To Next Page
Loading...
