Secure Power SP203 - Output Voltage Setting

Secure Power Ltd
User Manual
15
4.3.2 Bypass mode setting
Enter the setting interface. Press and hold the function setting key for more than 2 seconds, then
come to setting interface, Press and hold the function setting key for more than half a
second(less than 2 seconds), select the function setting, choose the bypass output interface, at the
moment, the letters “bPS” will flash as following:
Enter the Bypass output selecting interface. Press and hold the function setting key for more than
half a second(less than 2 seconds), then come to setting interface of bPS, at this time, the letters
“bPS” will light for a long time. The “ON” below the bPS will flash. Press and hold the inquiring key
for more than half a second (less than 2 seconds) to determine whether the bPS function is used or
not. If used, the corresponding word is “ON”, if not, the word is “OFF”. It can be determined by
yourself.
Confirm the Bypass output selecting interface. After selecting ON or OFF, press and hold the function
setting key for more than half a second (less than 2 seconds), Now, the bPS setting function is
completed and the “ON” or “OFF” below the “bPS” will light without flash.