Seeley Braemar LSHV35D1S

Questions and Answers

J
jsilvaAug 8, 2025
What to do if my Seeley Braemar LSHV35D1S Inverter air conditioner does not run?
- B
  Brandi GonzalezAug 8, 2025
  If your Seeley Inverter air conditioner isn't running, there could be several reasons. First, there might be a power failure, in which case you should wait for the power to resume. Second, a fuse might have blown, or a circuit breaker might be open; replace the fuse or reset the breaker. Finally, the thermostat adjustment might be too low in heating mode or too high in cooling mode. Check the thermostat setting, especially if you're using ‘I FEEL’ mode, and ensure the remote is in an appropriately cool or hot location.
K
kimberlyevansAug 12, 2025
Why is my Seeley Inverter remote controller not operating the air conditioner?
- M
  Mrs. Maria HillAug 13, 2025
  If your Seeley Inverter's remote controller isn't working, it might be out of range; the signal range is 8 meters. Poor signal reception could also be the issue; try removing any obstacles or sources of electrical interference. Lastly, check the batteries in the remote controller and replace them if needed, especially if there's no display.
J
janelaraAug 18, 2025
What to do if my Seeley Braemar LSHV35D1S has insufficient cooling?
- S
  Shawn ChoiAug 18, 2025
  If your Seeley Inverter isn't cooling enough, it could be because the room was very hot when you started the system; give the unit time to cool the room. Another reason may be that the air filter is dirty or blocked; clean the filter to resolve this.
D
Dylan JacobsonAug 22, 2025
Why can't I adjust the SET temperature on my Seeley Braemar LSHV35D1S?
- K
  Kristin FieldsAug 22, 2025
  If you can't adjust the SET temperature on your Seeley Inverter, it might be because the unit is operating in AUTO mode, where temperature settings are disabled. Alternatively, the temperature you're trying to set might be outside the allowable range, which is 16-30°C.
V
vmartinezAug 28, 2025
Why does my Seeley Inverter air conditioner make a clicking sound?
- M
  Mrs. Brandy RiggsAug 28, 2025
  If you hear a clicking sound from your Seeley Inverter air conditioner, especially during heating or cooling operation, it's likely due to plastic parts expanding or shrinking because of sudden temperature changes. This is normal.
B
bsmithSep 2, 2025
Why is my Seeley Braemar LSHV35D1S cooler not operating at full power?
- M
  melissa51Sep 2, 2025
  If your Seeley Inverter cooler isn't operating at full power, it's possible that DRED (Demand Response energy saving) mode has been activated by the Electricity Supplier. DRED will stop when grid power demands are reduced.