Why is my Seeley Air Conditioner not cooling enough?
If your Seeley Air Conditioner isn't cooling sufficiently, it might be because the room was very hot when you first started the system. Give the unit some time to cool the room down. Also, check if the air filter is dirty or blocked, and clean it if necessary.
What to do if my Seeley Air Conditioner remote controller is not working?
If the remote controller isn't operating your Seeley Air Conditioner, first ensure that you are within the 8m signal range. Then, check for any obstacles or electrical interference that might be affecting the signal. Finally, if there's no display on the remote, check and replace the batteries.
What to do if my Seeley Air Conditioner does not run?
If your Seeley Air Conditioner isn't running, check for a power failure and wait for the power to resume. Also, inspect the fuse and replace it if blown, or reset the circuit breaker if it's open. Finally, check the thermostat setting to ensure it's appropriately adjusted for cooling or heating mode.
Why can’t I adjust the temperature on my Seeley Air Conditioner?
If you can't adjust the set temperature on your Seeley Air Conditioner, it might be because the unit is operating in AUTO mode, where temperature settings are disabled. Alternatively, the temperature you're trying to set might be outside the allowable range of 16-30°C.
Why is my Seeley Air Conditioner not operating at full power?
Your Seeley Air Conditioner might not be operating at full power because DRED (Demand Response energy saving) mode has been activated by the Electricity Supplier. This mode will stop when grid power demands are reduced.
What to do if my Seeley Braemar SCHV10D1S air conditioner does not run?
If your Seeley Inverter air conditioner isn't running, first, check for a power outage and wait for the power to be restored. If the power is on, inspect the fuse and replace it if it's blown, or reset the circuit breaker if it's open. Lastly, make sure the thermostat is properly adjusted for heating or cooling mode.
Why does my Seeley Braemar SCHV10D1S air conditioner make a clicking sound?
If you hear a clicking sound from your Seeley Inverter air conditioner, it's likely due to plastic parts expanding or shrinking because of sudden temperature changes during heating or cooling. This is a normal occurrence.
Highlights crucial regulations on refrigerant use, disposal, and qualified technician requirements.
Advises on intended use for persons with reduced capabilities and supervision for children.
Instructions for setting the operational mode, temperature, and fan speed.
Covers temperature scales, ambient temp enquiry, fan shutdown, and error displays.
Schedule of tasks for the home owner/user, including filter cleaning and air filter replacement.
Provides probable causes and remedies for common problems like no operation or insufficient cooling.
To Next Page
General