37
TO SET - DIVE TIME REMAINING ALARM
(while in the Surface Mode)
Factory set for 0:00 (minutes), the Dive Time Remaining
Alarm can be set to values between 0:00 and 0:20
(minutes) in increments of 1 minute.
• Press Both buttons simultaneously, release when SET:
2 appears.
• Press and release the Advance (Front) button, the Units
screen appears with the set point flashing.
• Press the Advance (Front) button 9 more times.
• The graphic dtr and Alarm and Dive Mode icons appear
with the Dive Time Remaining value flashing (Fig.
34).
• Press and release the Select (Side) button to advance
the Alarm value in increments of one minute.
• Press the Advance (Front) button to accept the setting
and advance to Set Max PO2 Alarm, or press and hold
Both buttons for 2 seconds to revert to Surface Mode.
Fig. 34 - Set Dive Time Remaining
Alarm
To Next Page
Loading...
